You want to convert a date, a time, or both with distinct values for day, month, year, etc. to Epoch seconds.
use Time::Local; $TIME = timelocal($sec, $min, $hours, $mday, $mon, $year); $TIME = timegm($sec, $min, $hours, $mday, $mon, $year);
The built-in function
localtime converts an Epoch seconds value to distinct DMYHMS values; the
timelocal subroutine from the standard Time::Local module converts distinct DMYHMS values to an Epoch seconds value. Here's an example that shows how to find Epoch seconds for a time in the current day. It gets the day, month, and year values from
# $hours, $minutes, and $seconds represent a time today, # in the current time zone use Time::Local; $time = timelocal($seconds, $minutes, $hours, (localtime)[3,4,5]);
If you're passing month and year values to
timelocal, it expects values with the same range as those which
localtime returns. Namely, months start at 0, and years have 1900 subtracted from them.
timelocal function assumes the DMYHMS values represent a time in the current time zone. Time::Local also exports a
timegm subroutine that assumes the DMYHMS values represent a time in the GMT time zone. Unfortunately, there is no convenient way to convert from a time zone other than the current local time zone or GMT. The best you can do is convert to GMT and add or subtract the time zone offset in seconds.
This code illustrates both the use of
timegm and how to adjust the ranges of months and years:
# $day is day in month (1-31) # $month is month in year (1-12) # $year is four-digit year e.g., 1967 # $hours, $minutes and $seconds represent UTC time use Time::Local; $time = timegm($seconds, $minutes, $hours, $day, $month-1, $year-1900);
As explained in the introduction, Epoch seconds cannot hold values before
1901 or after
2038. Don't convert such dates to Epoch seconds - use a Date:: module from CPAN, and do your calculations with that